![]() Please post any feedback in the discussion for this release. I'm absolutely committed to getting the final release of 1.1.0 out before the new year. And I'd encourage you to ditch OctoPrint if you're not using any Octo plugins that you can't live without.At long last a new RC of ArcWelder is available! I've worked out a bunch of difficult enhancements, and just need some feedback before I push to live. Tl dr: The only time it's reasonable to use Arc Welder with Klipper is when you're streaming gcode from OctoPrint. And actually when you enable arc support Klipper is converting those arcs to line segments before it even sends the events to the firmware. However, Klipper is specifically built for speed and, assuming you're not streaming from OctoPrint, doesn't have any problem handling the gcode generated from higher resolution arcs. This is specifically a problem when streaming gcode from Octoprint to your firmware or when using slower controller boards with other firmware. This in turn prevents stuttering where bandwidth is a problem. The selling point of ArcWelder is that you can greatly reduce the number of gcode commands by converting multiple G0/G1 commands to G2/G3 commands. ![]() On the other hand there's not really and advantage to using ArcWelder with Klipper. ![]() Keeping the controls in the slicer give you the ability to make this adjustment and preview the resulting gcode. This is an acceptable trade-off for some models but not for others. Reducing the resolution can speed up a print since it reduces the number of corners. Practically speaking, if you do it in the slicer it's easier to change the resolution when needed and allows you to preview the sliced model before printing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |